Specifications

AT Command Set
TC35-ATC-01-V02.10 Page 65/145 02.10 / 23.05.2001
4.22 AT+CMEE Report mobile equipment error
Test command
AT+CMEE=?
Response
+CMEE: (list of supported <n>s) OK
Parameter
See write command
Read command
AT+CMEE?
Response
+CMEE: <n> OK
Parameter
See write command
Write command
AT+CMEE=<n>
TA disables or enables the use of result code +CME ERROR: <err> as an
indication of an error relating to ME functionality.
Response
OK
Parameter
<n> 0 disable result code
1 enable result code and use numeric values
2 enable result code and use verbose values
Reference
GSM 07.07
Note
The possible error result codes are listed in chapter 7
If using multiplex mode (see “AT+CMUX Enter multiplex mode”, pg. 67):
A setting with this command is only valid for the logical channel via it was
issued. The setting of the other channels may differ.