Specifications

AT Command Set
TC35-ATC-01-V02.10 Page 35/145 02.10 / 23.05.2001
3.2 AT+FBADMUL Error Threshold Multiplier
Read command
AT+FBADMUL
?
This command defines the “Copy-Quality-OK” multiplier. The number of lines
received with a bad pixel count is multiplied by this number. If the result exceeds
the total number of lines on the page the error rate is considered too high. A
threshold multiplier value of 20 corresponds to a 5% error rate. A value of 0 im-
plies that error checking is not present or disabled.
Response
<badmul> OK
Parameter
See write command
Write command
AT+FBADMUL
=<n>
Response
OK
If error is related to ME functionality:
ERROR
Parameter
<n> 0 – 20 – 255
Reference
EIA PN-2388
Note
Used for Faxclass 2 only
3.3 AT+FBOR Query data bit order
Test command
AT+FBOR=?
Query the bit order for receive-mode. The mode is set by the ME dependent on
the selected Service Class, see “AT+FCLASS Fax: Select, read or test service
class”, pg. 36.
Response
(list of supported bit order modes <bor>s) OK
Parameter
See write command
Read command
AT+FBOR?
Response
<bor> OK
Parameter
See write command
Write command
AT+FBOR=<bo
r>
Response
OK
Parameter
<bor> 0 direct bit order for both Phase C and for Phase B/D data.
1 Reversed bit order for Phase C data, direct Bit Order for Phase
B/D data.
Reference
EIA PN-2388
Note
Used for Faxclass 2 only