Specifications

AT Command Set
TC35-ATC-01-V02.10 Page 31/145 02.10 / 23.05.2001
2.42 AT+ILRR Set TE-TA local rate reporting
Test command
AT+ILRR=?
Response
+ILRR: (list of supported <value>s) OK
Parameter
See write command
Read command
AT+ILRR?
Response
+ILRR: <value> OK
Parameter
See write command
Write command
AT+ILRR=
<value>
This parameter setting determines whether or not an intermediate result code of
local rate is reported at connection setup. The rate is reported before the final
result code of the connection is transmitted to the TE.
Response
OK
Parameter
<value> 0 Disables reporting of local port rate
1 Enables reporting of local port rate
Intermediate result
+ILLR:<rate>
Note: Indicates port rate setting on connection.
Parameter
<rate> port rate setting on call connection in bit per second
0 (Autobauding, see pg. 10)
300
600
1200
2400
4800
9600
14400
19200
28800
38400
57600
115200
Reference
V.25ter
Note
If autobauding is active, the command A/ (and a/) can not be used.