Specifications

AT Command Set
TC35-ATC-01-V02.10 Page 28/145 02.10 / 23.05.2001
2.36 AT&V Display current configuration
Execute command
AT&V[<n>]
TA returns the current parameter setting.
Response
The following table shows four different kinds of responses depending on
whether the PIN is entered or not, and wether channel 1 is used or
communication is done via logical channels 2 or 3. This requires the multiplex
mode to be enabled (see “AT+CMUX Enter multiplex mode”, pg. 67).
Parameter
<n> 0 profile number
PIN entered or not required (see
AT+CPIN, pg. 73)
Required PIN not entered
Channel 1 (with
or without mul-
tiplex mode
enabled)
ACTIVE PROFILE:
E1 Q0 V1 X4 &C1 &D2 &S0 \Q0
S0:000 S3:013 S4:010 S5:008 S6:000
S7:060 S8:000 S10:002 S18:000
+CBST: 7,0,1
+CRLP: 61,61,78,6
+CR: 0
+FCLASS: 0
+CRC: 0
+CMGF: 0
+CNMI: 0,0,0,0,1
+ILRR: 0
+IPR: 19200
+CMEE: 2
^SMGO: 0,0
+CSMS: 0,1,1,1
^SACM: 0,"000000","000000"
^SCKS: 0,1
+CREG: 0
+CLIP: 0,2
+CAOC: 0
+COPS: 0,0,"operator"
OK
ACTIVE PROFILE:
E1 Q0 V1 X4 &C1 &D2 &S0 \Q0
S0:000 S3:013 S4:010 S5:008 S6:000
S7:060 S8:000 S10:002 S18:000
+CBST: 7,0,1
+CRLP: 61,61,78,6
+CR: 0
+FCLASS: 0
+ILRR: 0
+IPR: 19200
+CMEE: 2
^SCKS: 0,1
OK
Logical channels
2 and 3 (Multi-
plex mode en-
abled)
+CRC: 0
+CMGF: 0
+CNMI: 0,0,0,0,1
+ILRR: 0
+IPR: 19200
+CMEE: 2
^SMGO: 0,0
+CSMS: 0,1,1,1
^SACM: 0,"000000","000000"
^SCKS: 0,1
+CREG: 0
+CLIP: 0,2
+CAOC: 0
+COPS: 0,0,"operator"
OK
+ILRR: 0
+IPR: 19200
+CMEE: 2
^SCKS: 0,1
OK
Reference Note
Parameter values and order are subject to change.