Specifications

AT Command Set
TC35-ATC-01-V02.10 Page 125/145 02.10 / 23.05.2001
6.23 AT^SNFS Select audio hardware set
Test command
AT^SNFS=?
Response
^SNFS: (list of supported <audMode>s) OK
Parameter
See write command
Read command
AT^SNFS?
Response
^SNFS: <audMode> OK
Parameter
See write command
Write command
AT^SNFS=
<audMode>
Response
TA activates the selected audio mode.
OK
If error is related to ME functionality:
+ CME ERROR: <error>
Parameters
<audMode>
1 Audio mode 1: Standard mode approved for default handset, switched al-
ways through analog interface 1. Volume level is to be controlled with the
related knob of the default handset only. This handset can be used in audio
mode 4 with user defined parameters.
Note: The default parameters are determined for type approval and are not
adjustable by AT Commands in this audio mode.
2 Audio mode 2: Customer specific mode for basic handsfree (Siemens Car-
Kit), switched through analog interface 2; audio parameters can be adjusted
by AT Commands
3 Audio mode 3: Customer specific mode for mono-headset; audio parameters
can be adjusted by AT Commands; switched through analog interface 2
4 Audio mode 4: Customer specific mode for user handset switched through
analog interface 1; audio parameters can be adjusted by AT Commands
5 Audio mode 5: Customer specific mode switched through analog interface 1;
audio parameters can be adjusted by AT Commands
6 Audio mode 6: Customer specific mode switched through analog interface 2;
audio parameters can be adjusted by AT Commands
Reference
Siemens
Note