Specifications

AT Command Set
TC35-ATC-01-V02.10 Page 109/145 02.10 / 23.05.2001
ME is connected:
Serving Cell I Dedicated channel
chann rs dBm PLMN LAC cell NCC BCC PWR RXLev C1 I chann TS timAdv PWR dBm Q ChMod
10233-772620130066060305-10225I1024 15-762S_EFR
OK
Parameters
Serving Cell:
chann traffic channel number
rs RSSI value (0–63)
dBm receiving level in dBm
PLMN PLMN ID code
LAC location area code, see note below.
cell Cell ID, see note below.
NCC PLMN colour code
BCC Base Station colour code
PWR maximal power level used on RACH channel
RXLev minimal receiving level (in dBm) to allow registration
C1 coefficient for base station selection
Dedicated channel:
chann traffic channel number
Note: <chann> = 0 signals frequency hopping.
TS timeslot no.
timAdv timing advance in bits
PWR current power level
dBm receiving level in dBm
Q receiving quality (0–7)
ChMod channel mode (S_HR: Half rate, S_FR: Full rate, S_EFR: Enhanced
Full Rate)
Reference
Siemens
Note
1. If during a connection the radio cell is changed, the parameter LAC and Cell
will not be updated (see also +CREG, pg 79).
2. As a result of this command the requested output may be issued by the ME
at any moment (related to <period>).
To indicate such unsolicited result codes to a connected application, the ME
usually activates it´s Ring Line (Logic "0") for one second. This is not true
during unsolicited output of AT^MONI and AT^MONP.