Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 9 of 278 04.08.2003
0 Document history
This chapter reports modifications and improvements over previous versions of the document.
"AT Command Set" Version TC35i-ATC_V01.03=> TC35i-ATC_V01.05
Chapter AT command What is new
2.10 ATDL Added note regarding “LD” phonebook.
2.35 AT&F Added to list of factory settings: CSSN, CUSD
4.19 AT&V Updated list of current settings. Added note regarding AT^SMGO.
Added note regarding ^CSDH.
3 AT Commands for FAX: Revised introduction. Modified table of supported Service
Classes.
4.2 AT+CALA Modified description of parameter <n>.
Corrected notes on usage of alarm functions on several channels.
4.11 AT+CFUN CYCLIC SLEEP mode requires hardware flow control.
Added note on how to set SLEEP mode if Mux mode is active.
4.19 AT+CIND More detailed description of “call”.
4.28 AT+CMUX Deleted notes regarding usage of +++ in Mux mode.
Deleted note regarding AT1^SMSO in Mux mode.
Updated Table 16.
4.35.1 --- In subsection PIN1/PUK1, option AT+CPWD deleted.
4.33 AT+CPBS “LD” phonebook only intended for voice call numbers.
5.6 AT+CMGS More detailed description of send errors.
4.41 AT+CREG More detailed description of parameters and log-in attempts.
4.39 AT+CR Deleted note regarding influence of PLMN.
7.17 AT^SM20 Description of parameter <CmgwMode> applies also to
AT+CMGS.
7.24 AT^SNFA More detailed description of parameters.
7.27 AT^SNFI More detailed description of parameters.
7.29 AT^SNFO Parameter <outCalibrate>: Corrected formula for the calculation of
volume steps.
"AT Command Set" Version TC35i-ATC_V00.01 => TC35i-ATC_V01.00
Chapter AT command What is new
Throughout document: Applies to TC35i and TC35i Terminal.
2
nd
cover page New version of General Note
2.3 AT\Qn If XON/XOFF control is effective, send XON character to resume
data transmission prior to using +++ .
2.5 ATD Further details on CUG. Added notes regarding blacklist. Further
details regarding responses returned after dialing with ATD.
2.6 ATD><mem> Removed note that quotation marks (“”) are required for <mem> if
<mgsm> is used. Removed note regarding ATX.
2.7
2.8
ATD><n>
ATD><str>
Removed note regarding ATX.
2.20 ATS0 Further details regarding usability autoanswer mode during multi-
plex mode.
2.35 AT&F Updated list of restored parameters.