Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 37 of 278 04.08.2003
2.32 ATZ Set all current parameters to user defined profile
Execute command
ATZ[<value>]
Response
TA sets all current parameters to the user profile stored with AT&W. If a connec-
tion is in progress, it will be terminated.
Note: Any additional commands on the same command line will be ignored. A de-
lay of 300 ms is required before next command is sent, otherwise “OK” response
may be corrupted.
OK
Parameter
<value> [0] Reset to user profile
Reference
V.25ter
Note
TC35i can be assigned two profiles: the factory profile (restored with AT&F) and
the user profile (stored with AT&W).
Related chapters: AT&F in chapter 2.35, AT&W in chapter 2.38.
2.33 AT&C Set circuit Data Carrier Detect (DCD) function mode
Write command
AT&C[<value>]
Response
This parameter determines how the state of circuit 109 (DCD) relates to the de-
tection of received line signal from the distant end.
OK
If DCD is not supported by the interface
ERROR
Parameter
<value> [0] DCD line is always ON.
1 DCD line is ON in the presence of data carrier only.
Reference
V.25ter
Note
Factory default is 1.