Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 36 of 278 04.08.2003
2.29 ATT Select tone dialing
Execute command
ATT
Response
OK
Reference
V.25ter
Note
No effect for GSM
2.30 ATV Set result code format mode
Write command
ATV[<value>]
Response
This parameter setting determines the contents of the header and trailer transmit-
ted with result codes and information responses.
When <value> =0
0
When <value> =1
OK
Parameter
<value>
[0] Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1 Information response: <CR><LF><text><CR><LF>
Long result code format: <CR><LF><verbose code><CR><LF>
Reference
V.25ter
Note
In case of using the command without parameter <value> will be set to 0.
Information responses are listed in Chapter 8.1.4 (verbose code and numeric
code).
2.31 ATX Set CONNECT result code format and call monitoring
Write command
ATX[<value>]
Response
This parameter setting determines whether or not the TA detects the presence of
dial tone and busy signal and whether or not TA transmits particular result codes.
OK
Parameter
<value>
[0] CONNECT result code only returned, dial tone and busy de-
tection are both disabled
1 CONNECT<text> result code only returned, dial tone and busy
detection are both disabled
2 CONNECT<text> result code returned, dial tone detection is
enabled, busy detection is disabled
3 CONNECT<text> result code returned, dial tone detection is
disabled, busy detection is enabled
4 CONNECT<text> result code returned, dial tone and busy
detection are both enabled
Reference
V.25ter
Note
See chapter 8.1.4 for related <text>.