Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 34 of 278 04.08.2003
2.25 ATS7 Set number of seconds to wait for connection completion
Read command
ATS7?
Response
<n> OK
Write command
ATS7=<n>
Specifies the number of seconds the TA will wait for the completion of the call
setup when answering or originating a call. Also referred to as "no answer time-
out". To put it plainly, this is the time to wait for the carrier signal. If no carrier sig-
nal is received within the specified time, the TA hangs up.
Response
OK
Parameter
<n> 000 – 060 no. of seconds to wait for connection completion.
Reference
V.25ter
Note
· Values greater than 60 cause no error, but <n> will be restored to the maxi-
mum value of 60.
· If called party has specified a high value for ATS0=<n>, call setup may fail.
· The correlation between ATS7 and ATS0 is important.
Example: Call setup may fail if ATS7=30 and ATS0=20.
2.26 ATS8 Set number of seconds to wait for comma dial modifier
Read command
ATS8?
Response
<n> OK
Write command
ATS8=<n>
No effect for GSM
Response
OK
Reference
V.25ter
Note
2.27 ATS10 Set disconnect delay after indicating the absence of data carrier
Read command
ATS10?
Response
<n> OK
Write command
ATS10=<n>
This parameter setting determines the amount of time that the TA remains con-
nected in absence of a data carrier. If the data carrier is detected before discon-
nect, the TA remains connected.
Response
OK
Parameter
<n> 001-002-254 number of tenths of seconds of delay
Reference
V.25ter
Note