Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 32 of 278 04.08.2003
2.18 ATQ Set result code presentation mode
Write command
ATQ[<n>]
Response
Specifies whether or not the TA transmits any result code to the TE. Information
text transmitted in response is not affected by this setting.
If <n>=0:
OK
If <n>=1:
(none)
Parameter
<n> 0 DCE transmits result code
1 Result codes are suppressed and not transmitted
Reference
V.25ter
Note
2.19 ATP Select pulse dialing
Execute command
ATP
Response
OK
Reference
V.25ter
Note
No effect for GSM
2.20 ATS0 Set number of rings before automatically answering the call
Read command
ATS0?
Response
<n> OK
Write command
ATS0=<n>
Specifies whether or not the TA will accept an incoming call without user inter-
vention. <n> determines the number of rings to wait before the TA will automati-
cally answer.
Response
OK
Parameter
<n> 000 disables automatic answer mode
001-255 enables automatic answering after specified number of rings
Reference
V.25ter
Note
· If <n> is set too high, the calling party may hang up before the call can be
automatically answered.
· The correlation between ATS7 and ATS0 is important.
Example: Call setup may fail if ATS0=20 and ATS7=30.
· The selected value is local to the interface. It is possible to set different values
on different interfaces (channels). In such cases the interface ‘wins’ which is
idle and uses the smallest ATS0 value.
· Autoanswer mode can be set on each multiplexer channel. On Channels 2
and 3 it applies only to voice calls.