Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 29 of 278 04.08.2003
2.11 ATE Enable command echo
Write command
ATE[<value>]
This setting determines whether or not the TA echoes characters received from
TE during command state.
Response
OK
Parameter
<value> 0 Echo mode off
1 Echo mode on
Reference
V.25ter
Note
In case of using the command without parameter, <value> is set to 0.
2.12 ATH Disconnect existing connection
Execute command
ATH[n]
Disconnects any call in progress, such as voice, fax or CSD calls. See notes be-
low for multiplex mode.
Response
OK
Note:
OK is issued after circuit 109 (DCD) is turned off, if it was previously on.
Parameter
<n> [0] terminate call
Reference
V.25ter
Note
Using ATH in Multiplex mode:
· ATH terminates every voice, fax or CSD call, no matter on which logical chan-
nel ATH was executed.
For example, if ATH is executed on channel 2 or 3, a voice call on channel 1
will be disconnected, too.
This behavior is in accordance with ITU-T V.25 ter; (07/97, see “6.3.6 Hook
control“: "ATH is terminating any call in progress").