Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 203 of 278 04.08.2003
<passwd> password. For each <fac> a different type of password is required.
See Chapters 4.38 and 7.42 for instructions of how to specify pass-
words.
<class> integer or sum of integers each representing a <class> of information:
1 voice
2 data
4 fax
8 short message service
16 data circuit sync
32 data circuit async
64 dedicated packet access
128 dedicated PAD access
x combination of some of the above classes.
For example, the default setting 7 represents the sum of the
integers 1, 2 and 4 (call barring for voice, data and fax). The
value 255 covers all classes. If the <class> parameter is
omitted, the default value 7 is used.
See examples in 4.21.3 for correct handling of class numbers.
<class> 2 (data) comprises all those <class> values between 16 and
128, that are supported both by the network and the MS. This means,
a setting made for <class> 2 applies to all remaining data classes (if
supported). In addition, you can assign a different setting to a specific
class. For example, you can activate call barring for all data classes,
but deactivate it for a specific data class.
<status> 0 off
1 on
Reference
GSM 07.07
GSM 02.04,
GSM 02.88
Note
See also specification of AT+CLCK in GSM 07.07 and further details in Chapter
4.21.
The command has been implemented with the full set of <class> parameters
according to GSM 07.07. For actual applicability of a specific <fac> to a specific
service or service group (a specific <class> value) please consult table A.1 of
GSM 02.04.