Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 162 of 278 04.08.2003
65)). In the case of CBS: <ra> GSM 03.40 TP-Recipient-Address Ad-
dress-Value field in string format; BCD numbers (or GSM default alpha-
bet characters) are converted into characters; type of address given by
<tora>
<pid> GSM 03.40 TP-Protocol-Identifier in integer format (default 0)
<ra> GSM 03.40 TP-Recipient-Address Address-Value field in string format;
BCD numbers (or GSM default alphabet characters) are converted to
characters of the currently selected TE character set (refer command
AT+CSCS Select TE character set.); type of address given by <tora>
<sca> GSM 04.11 RP SC address Address-Value field in string format; BCD
numbers (or GSM default alphabet characters) are converted to charac-
ters of the currently selected TE character set (refer command
AT+CSCS Select TE character set); type of address given by <tosca>
<scts> GSM 03.40 TP-Service-Centre-Time-Stamp in time-string format (refer
<dt>)
<st> GSM 03.40 TP-Status in integer format
<toda> GSM 04.11 TP-Destination-Address Type-of-Address octet in integer
format (when first character of <da> is + (IRA 43) default is 145, other-
wise default is 129)
<tooa> GSM 04.11 TP-Originating-Address Type-of-Address octet in integer
format (default refer<toda>)
<tora> GSM 04.11 TP-Recipient-Address Type-of-Address octet in integer for-
mat (default refer<toda>)
<tosca> GSM 04.11 RP SC address Type-of-Address octet in integer format (de-
fault refer <toda>)
<vp> depending on SMS-SUBMIT <fo> setting: GSM 03.40 TP-Validity-Period
either in integer format (default 167) or in time-string format (refer <dt>)
Reference
GSM 07.05
Note
· Response if AT+CMGR is used to read an empty record index: +CMGR: 0,,0
· Response if AT+CMGR is used to read a non-existant record index:
+CMS ERROR: invalid memory index.
· The parameters <ra> and <tora> will only be displayed if the parameter <ra> of
the AT^SSCONF command is set to 1. See Chapter 7.44 for details on
AT^SSCONF.
· In PDU status reports, the filler “FF” will not be displayed anymore if the pa-
rameter <FF> of the AT^SSCONF command is set to 1.
· This command can be used only after the sms data from the SIM have been
read successfully for the first time. Reading starts after successful SIM authen-
tication has been performed, and may take up to 30 seconds depending on the
SIM used. While the read process is in progress, an attempt to use any of the
sms read commands will result in "+CME Error: 14" (SIM busy).