Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 159 of 278 04.08.2003
stead of characters. This needs to be taken into account when using
the commands AT+CMGL, AT+CMGR and AT^SMGL.
<index> integer type; value in the range of location numbers supported by
the associated memory
<mr> GSM 03.40 TP-Message-Reference in integer format
<oa> GSM 03.40 TP-Originating-Address Address-Value field in string
format; BCD numbers (or GSM default alphabet characters) are
converted into characters; type of address given by <tooa>
<pdu> In the case of SMS: GSM 04.11 SC address followed by GSM 03.40
TPDU in hexadecimal format: ME/TA converts each octet of TP data
unit into hexadecimal numbers containing two IRA characters (e.g.
octet with integer value 42 is presented to TE as two characters 2A
(IRA 50 and 65)). In the case of CBS: GSM 03.41 TPDU in hexa-
decimal format.
<ra> GSM 03.40 TP-Recipient-Address Address-Value field in string
format; BCD numbers (or GSM default alphabet characters) are
converted into characters; type of address given by <tora>
<scts> GSM 03.40 TP- Service-Centre-Time-Stamp in time-string format
(refer <dt>)
<st> GSM 03.40 TP-Status in integer format
<toda> GSM 04.11 TP-Destination-Address Type-of-Address octet in inte-
ger format (when first character of <da> is + (IRA 43) default is 145,
otherwise default is 129)
<tooa> GSM 04.11 TP-Originating-Address Type-of-Address octet in inte-
ger format (default refer<toda>)
<tora> GSM 04.11 TP-Recipient-Address Type-of-Address octet in integer
format (default refer<toda>)
Reference
GSM 07.05
Note
· The parameters <ra> and <tora> will only be displayed if the parameter
<ra> of the AT^SSCONF command is set to 1.
· In PDU status reports, the filler “FF” will not be displayed anymore if the
parameter <FF> of the AT^SSCONF command is set to 1.
· See Chapter 7.44 for details on AT^SSCONF.
· This command can be used only after the sms data from the SIM have
been read successfully for the first time. Reading starts after successful
SIM authentication has been performed, and may take up to 30 seconds
depending on the SIM used. While the read process is in progress, an at-
tempt to use any of the sms read commands will result in "+CME Error: 14"
(SIM busy).