Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 140 of 278 04.08.2003
4.39 AT+CR Service reporting control
Test command
AT+CR=?
Response
+CR: (list of supported <mode>s) OK
Parameter
See write command
Read command
AT+CR?
Response
+CR: <mode> OK
Parameter
See write command
Write command
AT+CR=<mode>
Response
Configures the TA whether or not to transmit an intermediate result code +CR:
<serv> to TE when a call is being set up.
OK
Parameter
<mode> 0 disable
1 enable
The selected mode can be stored to the user profile (AT&W) and reset to its
factory default (AT&F).
Intermediate result code
If enabled, an intermediate result code is transmitted at the point during connect
negotiation when the TA has determined the speed and quality of service to be
used, before any error control or data compression reports are transmitted, and
before any final result code (e.g. CONNECT) appears.
+CR:<serv>
Parameter
<serv> REL ASYNC asynchronous non-transparent
Reference
GSM 07.07
Note
· PIN is required for the Write command only.