Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 105 of 278 04.08.2003
+CPIN: SIM PIN "PS"lock password is not needed.
AT+CPIN=”9999”
OK
Example 4
To operate the mobile with other SIM card than the one used for the "PS" lock:
Enter SIM PIN of present card, followed by "PS" lock password.
AT+CPIN? Enter SIM PIN of present SIM card.
+CPIN: SIM PIN
AT+CPIN=”1111”
OK SIM PIN accepted.
AT+CPIN?
+CPIN: PH-SIM PIN "PS" lock password is required.
AT+CPIN=”3333”
OK "PS" lock password has been accepted.
Example 5
Attempt to unblock the "PS" lock using an invalid password:
AT+CPIN? Enter SIM PIN of present SIM card.
+CPIN: SIM PIN
AT+CPIN=”1111”
OK SIM PIN accepted.
AT+CPIN?
+CPIN: PH-SIM PIN "PS" lock password is required.
AT+CPIN=”4444” Bad password is given:
+CME ERROR: incorrect password
After the "PS" lock password was incorrectly entered three times in a row:
AT+CPIN?
+CPIN: PH-SIM PUK Master Phone Code is required (8-digit code
available from the manufacturer. See Chapter
4.35.1).
AT+CPIN=”12345678” Master Phone Code has been accepted. As a
result, the mobile is operational, and the "PS"
lock is totally removed. If needed, it must be set
once again.
Example 6
Attempt to unblock the "PS" lock using an invalid Master Phone Code: Due to
the timing algorithm explained in Chapter 4.35.1 the intervals between each at-
tempt are getting longer. See also AT^SPIC in Chapter 7.38.
Example 7
As an alternative to the AT+CPIN command you can use AT+CPWD. In this
case the following syntax shall be observed: AT+CPWD=PS,Master Phone
Code[,new password].
AT+CPWD=”PS”,”12345678” Deactivates the "PS" lock.