Operating Instructions
Table Of Contents
- How to Use This Manual
- Chapter 1—Introduction
- Chapter 2—Hardware Features
- 16- and 24-Point Compact Series Diagram
- 36-Point Compact Series Product Diagram
- Supported Point Types
- Compact Series Backup Batteries
- Using Auto Restore and Database Backup to Flash
- Memory
- Communication Connections
- Compact Series Smoke Control Application Requirements
- HOA (Hand-Off-Auto) Upgrade Kits
- PXM10S/T Product Overview and Description
- Unitary Equipment Controller
- TX-I/O Product Range Overview
- PX Series Enclosures and Service Boxes
- Chapter 3—Applications
- Chapter 4—Troubleshooting
- Glossary
- Index
Chapter 2—Hardware Features
HOA (Hand-Off-Auto) Upgrade Kits
0
51 |
93
Siemens Industry, Inc.
Owner's Manual
588-682
Building Technologies
2019-01-25
Menu/Submenu
Step
Description
Rotate
DIAL
to highlight the
last point (bottom of screen),
and then rotate
DIAL
once
more.
Refreshes the screen and displays the previous screens
last highlighted point, as well as the next series of points.
Repeat steps until you reach
the end of the point list.
The number of points you can enter is dependent on the
number of points stored at the host’s field panel database,
and sub network devices connected/configured to the
host’s field panel you are connected to.
Press
ESC
. Returns you the Points menu.
Press
INFO
. Displays detailed point information of selected point.
Scrolling the List of Points
The point name is displayed in the left column and values in the right column.
For TECs, the prefix is the TEC name; and the exposed point in the Points menu is the
DAY.NGT subpoint. To see a complete list of the devices subpoints, highlight the
DAY.NGT point, and then press DIAL/OK.
TEC Subpoints Menu with List of Device Subpoints
NOTE:
Based on FLN speed and network traffic, there may be a delay in displaying a full
point database.