Operating Instructions
Table Of Contents
- Cyber security disclaimer
- How to Use This Manual
- Chapter 1—Introduction
- Chapter 2—Hardware Features
- TC Modular Product Diagram
- Expansion Module Product Diagram
- Modular Series Backup Batteries
- Memory
- Communication Connections
- Modular Series Specifications
- Modular Series Smoke Control Application Requirements
- PXM10S/T Product Overview and Description
- TX-I/O Product Range Overview
- PX Series Enclosures and Service Boxes
- Chapter 3—Applications
- Chapter 4—Troubleshooting
- Glossary
- Index
Chapter 2—Hardware Features
Communication Connections
0
31 |
79
Siemens Industry, Inc.
Owner's Manual
588-781
Building Technologies
2018-10-01
If a field panel is coldstarted or it’s the first time the panel is powered up, it takes
approximately 15 to 30 seconds after connection before the PXM10S and PXM10T
module is operational.
Requirements
System Requirements
The PXM10S and PXM10T modules can be used with Compact platforms (TC-36, TC-
24, and TC-16), as well as with the TC Modular field panels.
● All hardware must be installed.
● Power must be available to all devices.
● System components must be installed, running, and checked out by an appropriate
system representative.
Hardware Platform
The PXM10T and PXM10S modules can be used on all Siemens Compact and
Modular series controllers. An additional connecting ribbon cable (part number PXA-
HMI.CABLEP5) is required when mounting to a PXC16 or PXC24.
Firmware Platform
The PXM10T and PXM10S modules are compatible with all Siemens Compact and
Modular series controllers using Firmware Revision 3.2.2 or later (proprietary
protocol/BACnet).
Application Menus
The following application menus are provided with the PXM10S and PXM10T modules.
● Login
● Alarms
● Points (Command and Release)
● Point Monitor
● Logoff
● Settings
NOTE:
You must have sufficient operator access permissions to the Alarms, Points, and
Point Monitor applications to fully use all features and corresponding submenus.