Specifications

DSL/Cable Router User Guide
38
Management
• Print jobs can be managed like any Windows printer. Open the Printers folder (Start -
Settings - Printers) and double-click any printer to see the current print jobs.
• If the printer attached to the DSL/Cable Router is changed, just run this program again,
and select the correct printer.
• To delete a port created by this setup program, use the Windows Delete Port facility:
• Right-click any printer in the Printers folder, and select Properties.
• Locate the Delete Port button. This button is on the Details or Ports tab, depending
on your version or Windows.
• If the DSL/Cable Router's IP Address is changed, and you can no longer print, delete the
port (see procedure above) and re-install it.
Port Options
The options for the Print Port Driver are accessed via the Windows Port Settings button.
Use Start - Settings - Printers to open the Printers folder, then right-click the Printer, and
select Properties. The Port Settings button is on the Details or Port tab, depending on your
version of Windows.
An example screen is shown below:
Figure 24: Print Port Configuration
Items shown on this screen are as follows:
Port
If desired, click Browse to select a different device. (The Select
Device Port button is provided to allow this software to work
with multi-port models.)
The Port Name is shown in the Printer's Properties.
Banner
Check this option to print a banner page before each print job.
• If using a PostScript Printer, check the PostScript box.
• The User Name will be printed on the banner page.
Retry
Interval
Sets how often Windows will poll the DSL/Cable Router to
establish a connection when the printer is busy. Increase this
value if you get too many warning messages.