User guide

©
Siemens AG 2003, L:\Mobil\R65\SP65\en\FUG\von_itl\SP65_CallSetup.fm
Setup80
VAR Language: en; VAR issue date: 041104
left page (80) of SP65 FUG en, A31008-H7450-A1-1-7619 (03.03.2005, 11:41)
Setup
Call setup
C ¢T¢Call setup
¢Select function.
Hide ID b
When you make a call, your phone
number can be displayed on the
recipient's display (depending on the
service providers).
To suppress this display, you can
enable the “Hide ID” mode for all sub-
sequent calls or just for the next call.
You may need to register separately
with your service provider for these
functions.
Call waiting b
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it.
Divert
You can specify the conditions under
which calls should be diverted to
your mailbox or other numbers.
Status check
You can check the current divert sta-
tus for all conditions. After a short
pause, the current situation is trans-
mitted by the network and dis-
played.
Ö Condition set.
Õ Not set.
Ô Display if status is
unknown (e.g. with
a new SIM card).
Clear all
b
All set diversions are cleared.
Setting up call divert (example)
The most common condition for call
divert is, for example:
Unanswered
b
I
Select Unanswered.
(Includes the conditions
Not reachable, No reply,
Busy, see below)
C Confirm.
Set Select.
C Confirm.
Ï
/
J
Select or enter the phone
number to which the calls
are to be diverted.
§Mailbox§ Use existing mail-
box phone numbers, or
enter them if necessary.
§OK§ Confirm. After a short
pause, the setting is con-
firmed by the network.