Network Hardware User Manual

382 U3585-J-Z125-8-76
NPS0533 Messages
NPS0533 SYSTEM ERROR IN ’/START-TASK-MEASUREMENT’ OR ’/STOP-TASK-MEASUREMENT’ COMMAND:
CODE=(&00)
Meaning
This message is for diagnostic purposes only.
NPS0534 MONITORING PROGRAM ’(&00)’ NOT COMPLETELY DEFINED. STATEMENT REJECTED.
Meaning
An attempt was made to start a not completely defined monitoring program.
Response
Define montoring program completely and repeat statement.
NPS0535 ’//SET-BCAM-CONNECTION-PARAMETERS’ STATEMENT NOT SPECIFIED. STATEMENT REJECTED.
Meaning
The //ADD-BCAM-CONNECTION-SET statement cannot be specified unless
//SET-BCAM-CONNECTION-PARAMETERS statement is specified first.
Response
Enter the //SET-BCAM-CONNECTION-SET-PARAMETERS statement and repeat your
original entry.
NPS0536 MORE THAN 32 CONNECTION SETS DEFINED. STATEMENT REJECTED.
Meaning
Maximal 32 connection sets can be monitored by measurement program
BCAM-CONNECTION. Statement rejected.
Response
Use the //REMOVE-BCAM-CONNECTION-SET statement to terminate monitoring of
superfluous connection sets and repeat your original entry.
NPS0537 NAME OF CONNECTION SET INVALID. STATEMENT REJECTED.
Meaning
Possible reasons:
- The specified name in the //ADD-BCAM-CONNECTION-SET statement is already
defined.
- The specified name in the //REMOVE-BCAM-CONNECTION-SET statement does
not exist.
NPS0538 CONNECTION SET DEFINITION IS ALREADY EXISTING. STATEMENT REJECTED.
Meaning
There is already a connection set defined that monitors the same connections.
NPS0539 WARNING: NO CONNECTION SET REMOVED
Meaning
The specified connection set does not exist.