Network Hardware User Manual

U3585-J-Z125-8-76 373
Messages NPS0033
NPS0033 UNEXPECTED END OF INPUT FILE
(B) Routing code: R Weight: 99
Meaning
Possible reasons:
- An end-of-file condition was encountered in batch mode.
- In interactive mode with statement input from a file, an end-of-file
condition was encountered when attempting to read a continuation line.
If the end-of-file condition is encountered while reading the first line of a statement, SYSDTA
is set to (PRIMARY) without this message being displayed.
NPS0035 INVALID BS2000 COMMAND
(B) Routing code: R Weight: 99
Meaning
An invalid BS2000 command has been issued as an SM2 statement in batch mode.
NPS0036 ’(&00)’ MACRO ERROR. RETURN CODE ’(&01)’
(B) Routing code: R Weight: 99
Meaning
An error has occurred during execution of the specified macro.
Depending on the error, SM2 either continues program execution, i.e. requests a corrected
statement via ENTER COMMAND, or terminates.
(&01): return code of the macro (cf. the ’Executive Macros’ manual).
NPS0037 SM2 TERMINATED NORMALLY
(B) Routing code: R Weight: 50
NPS0038 SM2 TERMINATED ABNORMALLY
(B) Routing code: R Weight: 99
Meaning
A serious program error has occurred, leading to immediate program termination.
NPS0039 FORMATTED OUTPUT ONLY POSSIBLE TO SYSLST
(B) Routing code: R Weight: 99
Meaning
Terminal output is not possible because:
- SM2 is running in batch mode, or
- the terminal has less than 80 columns, or
- the terminal has less than 24 lines.
Screen and status diagrams are put out to SYSLST.