Network Hardware User Manual

366 U3585-J-Z125-8-76
NPC0055 Messages
NPC0055 ’//SET-COSMOS-PARAMETER’ STATEMENT NOT SPECIFIED
Meaning
The statement //ADD-COSMOS-EVENT, //REMOVE-COSMOS-EVENT,
//MODIFY-COSMOS-PARAMETER, //INIT-COSMOS or
//START-MEASUREMENT-PROGRAM COSMOS cannot be specified unless
//SET-COSMOS-PARAMETER statement
is specified.
The statement has been rejected.
Response
Enter the statement //SET-COSMOS-PARAMETER and repeat your original entry.
NPC0056 STATEMENT ’(&00)’ NOT ALLOWED
Meaning
The statement //SET-COSMOS-PARAMETER, //MODIFY-COSMOS-PARAMETER,
//ADD-COSMOS-EVENT or //REMOVE-COSMOS-EVENT are not allowed between the
statements //INIT-COSMOS and //START-MEASUREMENT-PROGRAM COSMOS.
The statement has been rejected.
NPC0057 SYSTEM ERROR DURING CREATE OF SUBSYSTEM COSMOS.
Meaning
Error in starting of the subsystem COSMOSduring //INIT-COSMOS or
//START-MEASUREMENT-PROGRAM COSMOS.
You can determine the detailed error cause using the trace entries of the //SHOW-SM2-
STATUS function.
NPC0058 SYSTEM ERROR IN COSMOS-MODULES
Meaning
A system error has occured in COSMOS during program execution.
You can determine the detailed error cause using the trace entries of the
//SHOW-SM2-STATUS function.
NPC0059 WARNING : ’(&00)’ NOT FOUND IN SYSTEM
Meaning
When defining the monitoring program COSMOS, an value (JOBNAME,CATEGORY,
TSN,USERID) for the parameter TASK-SELECTION was specified that could not be found
in the system at the time of the measurement initialization or the measurement start.
NPC0060 WARNING : MACRO-ERROR DURING COSMOS EXECUTION
Meaning
During COSMOS-execution a macro returned an error.
For more infos you can determine the detailed error cause using the trace entries of the //
SHOW-SM2-STATUS function.