Umweltdeklaration

EPD - Type II
According to ISO 14021
Steel Spring, Parts 1.400 … 1.402g
Steel <=5% alloyed Parts 184g
Steel >5% alloyed Washers, Springs 62g
Sn / Sn alloy Parts 1g
Mineral oil Hydraulic Fluid 242g
Housing: PA6, Spring: steel, Insert: brass, Screw: stee Terminal
Microswitch
Wire: copper, Insulation :ETFE Cable / Wire 7g
FR4; halogenated FR4 105x60 mm 47 … 48g
*Variant parts list
[g]
Total weight of device
Cabling entrance
Cover Complete, Manual Adjuste
r
Housing, Piston
Spring, Parts
FR4 105x60 mm
Typical energy consumption
[kWh/a]
Packaging
Others
PCBAs (Printed Circuit Board
assembled)
9
48
1.180
1.399
SKD62UA
3.775
11
257257
9
1.180
1.399
46
10
318
1.401
876
9
46
SKD62
3.531
46 46
88
876
257
SKD60
3.531
10
318
1.401
SKD60U
3.773
1111
SKD62U
3.774
1.399
1.180
Printed Paper
Comments
The device should not be disposed of as unsorted municipal waste. The special treatment for specific components may be
mandated by law or ecologically sensible.
Observe all local and applicable laws.
Disposal
Regulation (EC) No. 1907/2006 (REACH)
The device is halogen-free with exception of:
Cables; Insulation tubing; PCBA
Environmental benefits
The actuator reduces consumption of energy due to switch off in end position. **
** Not valid for the U.S. Market
Legal Disclaimer: This declaration is for information purpose only.
EU-directive 2011/65/EU (RoHS)
The device is free from substances which interfere with lacquer wetting.
The device does not contain substances in concentrations and applications banned under the EU RoHS Directive.
To the best of our knowledge and according to the information of our suppliers the above mentioned device and its packaging contain no substances of the
candidate list according to Article 59 (1, 10) of the regulation (EC) No. 1907/2006 concerning the Registration, Evaluation, Authorisation and Restriction of
Chemicals (REACH) in concentrations above 0.1 % w/w.
(Status according to the creation date of this document.)
3429292929
Page 2/3