Installation Instructions

Document Number: 129-185
Installation Instructions
September 24, 2018
Page 2 of 9 Siemens Industry, Inc.
Installation
If you are mounting an actuator on a new valve, begin
with the instructions in Figure 6.
Removing the Actuator from the Valve
Figure 3.
Figure 4.
Figure 5.
Figure 6.
Preparation for Mounting an Actuator on a Valve.
Figure 7. Preparing a New Valve.
NOTE: Install the stem heating element (P/N ASZ6.6),
if used, before proceeding to Figure 8.
Figure 8.
NOTE: Place the narrow opening end of the nut over
the valve stem first.
Figure 9.
NOTE: Be careful not to break the washer.
4