User's Manual

B-6
1010NFM-3J
Appendix
Data Display Mode
After you complete the installation, you can toggle between Installation Menu mode to Data Display
mode. This is the same as using the <MENU> key on the 1010 keypad (see manual). The PC key-
board equivalent to the <MENU> key is <CNTRL> + <L>. Note that the 1010 RS-232 interface does
not support graphics. Therefore, when you use HyperTerminal to view the data display screens, you
will see the same data in alphanumeric form only (as shown below). You can still use the <Up Arrow>
and <Down Arrow> to switch between available display screens.
NOTE: To facilitate connecting through modems, the [Menu] command times out after three
minutes of inactivity. To maintain a longer connection type: Menu 1000 and press <ENT>.
The optional number is the amount in minutes that the connection will be maintained.
Typing [Menu 1000] essentially keeps the interface alive until you cancel it.
Siemens Site [1]
Select Meter Type
Meter Facilities
Meter Type Single Channel
This is the current flow
reading and flow units.
(This would be a large
graphic characters on
the1010 screen.
This is the current measured liquid
sonic velocity (Vs).
This is the flow
total display.
This is the name of the current active
site setup. The [1] indicates that
measurement channel is currently
active.
This is the current flow
reading and flow units.
(This would be a large
graphic character on
the 1010 screen
This is the flow
Total display
This is the current measured liquid
sonic velocity (Vs).
This is the name of the current active
site setup. The [1] indicates that the
measurement channel is currently
active.