User's Manual

6-6

1010NFM-3JSection 6

To move the highlight to [Install Flow Tube] press . Press to access the Install Flow Tube

menu.

To access the Flow Tube option list press . Note that this list shows the currently available flow

tube sizes. The number is the size (e.g., 1). The letter represents the material (e.g., S = Steel, P =

PVC, T = Teflon, K = Kynar). In this example, we will install a size 1S Flow Tube. This 1011FTP-1S

(Stainless Steel) unit uses a 5/8” Swagelok Tube Fitting.

To select size 1S press . This moves the highlight to [Install Completed?].

ENT

Siemens 2 Channel [1] FLOW1

Select FlowTube 1S

Install Completed? No

Empty FlowTube Set Chan Not Setup

Zero Flow Adjust Chan Not Setup

Pick Flow Tube size and Type

Install FlowTube

Siemens 2 Channel [1] FLOW1

Select FlowTube >1S

Install Completed? 1P

Empty FlowTube Set 1K

Zero Flow Adjust 1T

Pick Flow Tube size and Type

Install FlowTube

Note that the next menu down is Liquid Data. This menu allows you to enter Viscosity (in centistokes)

and the Density (specific gravity) data for the liquid to be measured. Data entry in this menu is

optional. The default values are those of Water at 68

°F (20°C). If you choose to edit these param-

eters, you should be aware that the viscosity of the liquid is an important factor. It governs the degree

of Reynolds Number compensation that the flow computer applies to the final rate output. Therefore,

flow data errors could result if you enter inaccurate data. Note that the Siemens Technical Service

Group may be able to provide the viscosity data for the liquid to be measured.