User's Manual

4-16

1010NFM-3J

Section 4

4.11 THE 1010 GRAPHIC DISPLAY SCREENS

The 1010 family Graphic Display Sub-System is a versatile resource which provides visual access to

all system variables and conditions. Depending upon your selection, details of the display my vary, but

all elements are always clearly labeled with units and variable names. You’re always free to move

through the displays by using the arrow keys. The meter will hold the last display selected indefinitely

or until the menu is selected by pressing the <Menu> key. When you again leave the menu, the last

selected display will be shown upon your return.

After completing the Site Setup, Check your local display screen to ensure that everything is operating

properly. The meter begins to measure flow as soon as you complete the transducer installation.

When you press to leave the menu, you will see the hybrid digital display screen (see page 4-

17). Note that it includes a digital flow, total numeric display and a Stripchart.

The StripChart Contains a number of special elements that deserve mention:

z The spanning of the stripchart’s vertical axis obeys the same user settings that define the span

limits for the analog outputs. If the variable “pegs,” the numerical expression of that variable will

also peg.

z Alarm limits, or thresholds, are indicated by triangular cursors shown near the stripchart bar.

These are also defined in the Data Span/Set/Cal area of the menu.

z Each time the stripchart is altered in a manner that can cause misinterpretation of already dis-

played data (re-spanned, new interval, etc.), a vertical bar is drawn on the stripchart. Only the data

to the left of the vertical bar is correctly displayed.

z Due to limitations in display area, certain rate or total units may be displayed with fewer characters

than are needed for unambiguous interpretation. Consult the 1010’s Flow and Total Units menu

cells for clarification in these cases.

Version This is the meter’s operating system version number. The Technical Services

Group may request this number during consultations.

Reset Date/Time Shows the date and time of this meter’s last <F4> reset.

Op System P/N Meter’s operating system part number.

Checksum Operating System verifying code. The Technical Services Group may request this

number during consultations.

Code Software Compile Date/Time. Operating System identifier. The Technical Services

Group may request this number during consultations.

System Time Use to set system time and date. Format: xx.xx.xx xx.xx.xx

System Info Menu Structure