User's Manual

3-4
1010NFM-3J
Section 3
3.1.5 REFLECT MODE - MOUNTING FRAMES AND SPACER BAR
The combination of a spacer bar with mounting frames is the easiest way to mount in Reflect Mode.
The result is a rigid structure that eliminates spacing measurements, and maintains the transducer-to-
transducer geometry. In addition, reflect mounting allows you to move the entire assembly while main-
taining the original transducer spacing.
1. Perform all required menu steps until the flow computer issues the number index and prompts
you to press to finish the transducer install routine. Stop at this point.
Note the number index value displayed in the Pick/Install menu. You will use this number to properly
space the transducers. Check to ensure that you have a matched set of transducers. They both should
have the same S/N number but marked with either an “A” or “B” (e.g., 100A and 100B).
ENT
INSTALLATION - REFLECT MOUNT WITH FRAMES AND SPACER BAR
NOTE: Minimum Ltn 0.75 in. (18 mm)
Mounting Strap
positioned around
Mounting Frame
Mounting Strap
Adjusting Screw
Optional on larger pipes,
you can link straps together
to surround pipe
Spacer Bar
(Front view)
Spacer Bar Platform &
Clamping Screw
Mounting Strap
positioned around
Mounting Frame
Optional on larger pipes,
you can link straps together
to surround pipe.
Space Bar Platform &
Clamping Screw
Space Bar
(Front View)
Mounting Strap
Adjusting screw
Mounting Strap
Transducer Clamping
Screw
N
ote optional 2nd
Mounting Strap
shown.
L
arger pipes may
need an additional
strap for a more
secure mount
Spacer Bar
Spring Clip
(Not present on some
models)
1012 Series
Mounting Frame
Spacer Bar
Platform and
clamping screw
Spring Clip
(Not present on
some
models)
Transducer Clamping
Screw
Spacer Bar
Spacer Bar
Platform and
clamping screw
Mounting Strap
Note operational
2nd Mounting Strap
shown.
Larger pipes may
need an additional
strap for a more
secure mount.
1012 Series
Mounting Frame