User manual

Configuration

Siemens Building Technologies

Fire Safety & Security Products 01.2009

6. Configure the port’s setting based on the PTZ camera manufacturer’s

instructions.

Î You can save your Camera changes by highlighting OK and pressing the

button.

Î Selecting Cancel exits the screen without saving the changes.

8.9.2 Alarm-Out screen

Highlight Alarm-Out in the Devices menu and press the button.

Î The Alarm-Out screen allows you to change the settings and establish a

schedule for each alarm output from the DVR.

Fig. 63 Alarm-Out Settings screen

Highlighting the box beside Dwell Time and pressing the

button allow you to set

the dwell time of the alarm output. Dwell times range from 5 seconds to 15 minutes.

You can add and edit alarm output schedules on this screen. Highlight the "+" and

press the

button to add a schedule. Highlighting the boxes under the column

heading and pressing the

button allow you to edit the information in those boxes.

The Day box allows you to select the days that the alarm schedule will be active.

The choices are: Sun, Mon, Tue, Wed, Thu, Fri, Sat, M~F, Hol and All.

The Range box allows you to set the time that the alarm schedule will be active in

15-minute increments from 00:00 to 24:00.

The Mode box allows you to set how the alarm reacts during the scheduled time.

When set to On, the Alarm-Out is active during the scheduled time. When set to

Event, the Alarm-Out is only active when there is an Event during the scheduled

time.

The Alarm-Out box allows you to select between Alarm Output and Beep (DVR’s

internal buzzer).

The

box allows you to delete an alarm output schedule. You will be asked to

confirm whether or not you really wish to delete the schedule.

Î You can save your Alarm-Out changes by highlighting Save and pressing the

button.

Î Selecting Cancel exits the screen without saving the changes.