User manual

Configuration

Siemens Building Technologies

Fire Safety & Security Products 01.2009

NOTE

You can associate multiple cameras with a camera that detects motion.

1. Highlight the box under the Record heading and press the button.

Î A list of cameras appears.

You can associate as many cameras with that camera as you wish. If the

DVR detects motion on the selected camera, it starts recording video from all

the associated cameras.

NOTE

For the Record action, the camera you select should be set to the Event or Time & Event recording

mode in the Record Schedule setup screen.

2. Highlight the box under the Alarm-Out heading and press the button.

3. Select between Alarm Output and Beep (DVR’s internal buzzer) that you

would like to activate and to sound whenever the DVR detects motion on the

selected camera’s input.

NOTE

For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in

the Alarm-Out setup screen (Schedule tab).

4. Highlight the box under Notify heading and press the button.

You can toggle the entire list On and Off by highlighting Notification and

pressing the

button. You can toggle the individual items On and Off by

highlighting that item and pressing the

button.

5. Highlight OK and press the

button to accept your changes.

NOTE

For the Notify action, the notify item you select should be enabled in the Notification setup screen

and the DVR should be registered in the RAS (Remote Administration System).

6. Highlight the desired box under the PTZ heading, and press the

button.

Î A list of PTZ presets appear.

7. Select the preset position for each PTZ camera, where you want PTZ

cameras to move to whenever the DVR detects motion on the selected

camera’s input.

Î You can save your Motion Detection changes by highlighting Save and

pressing the

button.

Î Selecting Cancel exits the screen without saving the changes.