User manual

Configuration

Siemens Building Technologies

Fire Safety & Security Products 01.2009

Select Activates highlighted blocks to detect motion.

Clear Deactivates highlighted blocks so that they will not detect motion.

Reverse Activates inactive highlighted blocks and deactivates active highlighted blocks.

Select All Activates all blocks to detect motion.

Clear All Deactivates all blocks so that they will not detect motion.

Reverse All Activates inactive blocks and deactivates active blocks.

OK Accepts changes and closes Zone setup.

Cancel Exits Zone setup without saving changes.

You can control excessive event logging and remote notification of motions

detected after the motion dwell time by adjusting the motion ignoring dwell

intervals.

Highlight the box beside Motion Ignoring Interval and press the

button.

Î A list of intervals ranging from 1 to 5 seconds or "Never" appears.

Î The DVR will not log and notify motion events occurred during the preset interval

range.

NOTE

The record action for motion events will not be affected by the Motion Ignoring function.

Highlighting Daytime Setup and pressing the button allow you to set up the

Daytime range.

Fig. 42 Daytime Setup screen

1. Highlight the box beside Daytime and press the

button.

2. Use the Up and Down arrow buttons to set the Daytime range.

Î The DVR will consider the remaining time range as the Nighttime.

3. Highlight the Actions tab.

Î The Motion Detection Actions screen displays.

Fig. 43 Motion Detection Actions screen

The DVR can be set to react to motion detection differently for each camera. Each

camera can be associated with another camera, trigger an Alarm-Out connector,

sound the DVR’s internal buzzer, notify a number of different devices, and/or move

PTZ cameras to preset positions.