User manual

Configuration
35
Siemens Building Technologies
Fire Safety & Security Products 01.2009
NOTE
You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network
administrator.
3. Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number.
The factory default LAN settings are:
IP Address: 192.168.1.129
Gateway: 192.168.1.254
Subnet Mask: 255.255.255.0
4. Highlight the box beside DNS Server. Press the Up and Down arrow buttons
to set the IP address of the DNS server.
5. Highlight the Port Number Setup… box and press the
button.
Î The Port Number Setup screen appears.
NOTE
You will need to get the appropriate Port Numbers for each RAS and Web Client related program
(Admin, Callback, Watch and Search) from your network administrator.
Fig. 30 Port Numbers setup screen
6. Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number.
The factory default port settings are:
Remote Admin: 8200
Remote Callback: 8201
Remote Watch: 8016
Remote Search: 10019
NOTE
The system restarts automatically after changing the port settings.
NOTE
Do NOT use the same port number for two different programs, otherwise, the DVR cannot be
connected with the PC running RAS or Web Client.
NOTE
When changing the port settings, you must change the port settings on the PC running RAS or Web
Client as well. Refer to the RAS manual for details.
Î Selecting "DHCP" from the Type and highlighting the Save button reads the
current IP address of the DVR configured by DHCP (Dynamic Host
Configuration Protocol) network.