User manual

Configuration
24
Siemens Building Technologies
Fire Safety & Security Products 01.2009
Up, Down, Left, Right Arrow
buttons
These buttons are used to navigate through menus and GUI.
The Up and Down arrow buttons are also used to change numbers
by highlighting a number in the menu and by increasing or
decreasing the number’s value.
These buttons are also used to control Pan and Tilt when in the PTZ
mode. In the playback mode, pressing the
button plays video
backward at high speed. Pressing the button again toggles the
playback speed from
, and , and the screen displays
, and respectively. While playing video, pressing
the
button plays video forward at high speed. Pressing the button
again toggles the playback speed from , , and , and
the screen displays
, , and respectively. When in
the pause mode, pressing the
button moves to the next image
and pressing the
button moves to the previous image.
ID button on remote control If a DVR System ID is set to 0, the infrared remote control will
control that DVR without any additional operations. (Refer to Section
8.11.1: Information screen for further information on setting the
S
ystem ID.) If the system ID is 1 to 4, you must to press the ID
button on the remote control and then press the number button (1 to
4) in order to control that DVR. If the System ID of two or more
DVRs is set to 0, those DVRs will react to the infrared remote
control at the same time.
Fig. 14 Infrared remote control
ID button Alarm button
Camera buttons Play/Clip button
Enter/Pause button PTZ/Zoom button
Menu button Arrow buttons
8.2 Turning on the power
Connecting the power cord to the DVR turns on the unit. The unit takes
approximately 60 seconds to initialize.