User manual

Installation
21
Siemens Building Technologies
Fire Safety & Security Products 01.2009
7.9 Connecting to the network port
Fig. 11 Network connector
The DVR can be networked using the 10/100Mb Ethernet connector. Connect a
Cat5 cable with an RJ-45 jack to the DVR connector. The DVR can be networked
with a computer for remote monitoring, searching, configuration and software
upgrades. See the Section 8: Configuration for configuring the Ethernet
c
onnections.
NOTE
The Network connecter is not designed to be connected directly with cable or wire intended for
outdoor use.
7.10 Connecting the power cord
Fig. 12 Power cord connector
Connect the AC power cord to the DVR and then to a wall outlet.
WARNING
Route power cords so that they are not a tripping hazard. Make certain the power cord will not be
pinched or abraded by furniture. Do not install power cords under rugs or carpet.
WARNING
The power cord has a grounding pin. If your power outlet does not have a grounding pin receptacle,
do not modify the plug.
Do not overload the circuit by plugging too many devices in to one circuit.
Your DVR is now ready to operate. Refer to Sections 8: Configuration and
9: Operation.