User manual

Configuration

Siemens Building Technologies

Fire Safety & Security Products 12.2008

You can associate as many Alarm-Outs with that camera as you wish. When

the DVR detects motion on the selected camera’s input, it triggers output

signals on all the associated Alarm-Out connectors. You can also have the

DVR’s internal buzzer sound if motion is detected on the selected camera.

NOTE

For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in

the Alarm-Out setup screen (Schedule tab).

3. Highlight the box under Notify heading and press the button.

You can toggle the entire list On and Off by highlighting Notification and

pressing the

button. You can toggle the individual items On and Off by

highlighting that item and pressing the

button.

4. Highlight OK and press the

button to accept your changes.

NOTE

For the Notify action, the notify item you select should be enabled in the Notification setup screen

and the DVR should be registered in the RAS (Remote Administration System).

Fig. 55 Motion Detection Action 2 screen

Actions 2

1. Highlight the desired box under the PTZ heading, and press the

button.

Î A list of PTZ presets appear.

2. Select the preset position for each PTZ camera, where you want PTZ

cameras to move to whenever the DVR detects motion on the selected

camera’s input.

3. Highlight the desired box under the Spot Monitor heading, and press the

button.

Î A list of SPOT monitors and cameras appears.

Each SPOT monitor can be associated with a camera. The DVR will display

the associated camera on the SPOT monitor whenever it detects motions on

the selected camera.

Î You can save your Motion Detection changes by highlighting Save and

pressing the

button.

Î Selecting Cancel exits the screen without saving the changes.