Operating instructions

Installing option modules

5.2 Iy module

SIPART PS2 with and without HART communications

Operating Instructions, 09/2007, A5E00074631-07

5.2 Iy module

Function

● The optional I

module indicates the current actuator position as a dual line signal with

= 4 to 20 mA. The I

module is potentially separated from the standard controller.

Thanks to the dynamic control, this module can report the arising operational faults

automatically.

● The current actuator position is indicated only after a successful initialization.

Figure 5-3 I

module

Device features

The I

module is:

● Single channel

● Potentially separated from the standard controller.

Installing the I

module

Proceed as follows to install the optional I

module:

1. Slide the I

module up to the end stop in the lower stack of the module rack.

2. Connect the module to the motherboard. For this purpose, use the 6-pole flat ribbon

cable provided.