Router User Manual

11.90 3 Operating Sequences

3.1.15 Data input/data output

Start the output of the R parameters by operating the

”START” softkey.

In the same way, you can select and start the output of data for the following:

– ”TOOL OFFSET”

– ”ZERO OFFSET”

– ”MACHINE DATA”

– ”PLC MACHINE DATA”

which have not been detailed here.

Using this softkey, you can stop data output at any time...

and continue it again with ”START”.

With the ”ETX-START” softkey you can output the end-

of-transmission character stored in the setting data.

The output is always made irrespective of whether RTS

line or Xon/Xoff protocol have been set.

or or

START

STOP

ETX

START

Using the keyboard, enter the

channel no.:

into the input field marked in

inverse video:

”1” for output of local

R parameters, channel 1

”2” for output of local

R parameters, channel 2

”0” for output of the

global R parameters

Note:

• A selection of the data, i.e. the output of a section as with ”PART PROGRAM” - is not possible!

• The input of a channel no. is only required by the control for ”R PARAMETERS”.

• Data output with or without leader or trailer can be set via setting data (SD 5016, bit 1).

3-85

SINUMERIK 810T, GA3 (BN)