Saw User Manual

Section D: Program description

Description of important program elements

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 91/107

Manual_SIMOTION Flying Saw_V1.4.doc

• From the “manual” state into the “starting position” state.

“Manual”

Æ “Disable” Æ “Starting position”

10.3.3 Checking the input parameters and parameterization of the

technology settings that are absolutely necessary

This program function is only active in the error state if it was activated by

the user using the restart bit.

The following are monitored:

• The existence of specified TOs.

• The function (positioning axis, synchronous axis, …)

• Special properties/features required for the template, such as: Modulo

axis and modulo value.

Deviations with respect to the template are displayed as fault messages.

Parameterization of the technology objects absolutely required is carried-

out in another program part.

The parameters that are therefore changed are described in

Chapter 7.4

Setting-up the required technology objects

and Chapter 7.5 Assigning

the synchronous relationships

10.3.4 State machine of the “FlyingSaw FB”

The state machines of the “FlyingSaw FB” are described in the following

diagram. It includes possible operating states that can be activated and

clearly shows the possible state transitions that may be initiated by the

user.