Saw User Manual

Section C: Integrating the core “flying saw” functions

Integrating the core “flying saw” functions

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 78/107

Manual_SIMOTION Flying Saw_V1.4.doc

7.5 Assigning the synchronous relationships

7.5.1 FlyingSawAxis_SYNCHRONOUS_OPERATION

Configuration

•

Select the MaterialAxis as master (leading) axis

• Select setpoint coupling as coupling type.

Pre-assignment (gear synchronization)

•

Synchronizing:

Enter the synchronizing position of the master (leading) axis and

slave (following) axis

(this is checked and corrected by the FlyingSaw FB)

• Position reference:

Synchronize before the synchronizing position

(this is checked and corrected by the FlyingSaw FB)

• SyncPos master (leading) value:

0.0

(the FlyingSaw FB enters the actual value)

• SyncPos slave (following) axis:

0.0

(the FlyingSaw FB enters the actual value)

• The other values are no longer relevant.

Pre-assignment (dynamic)

•

Profile input: Time-related synchronizing profile

(this is checked and corrected by the FlyingSaw FB)

• Please select the dynamic parameters of the time-related

synchronization so that the FlyingSawAxis does not reach the dynamic

limits when synchronizing and de-synchronizing.