Saw User Manual

Section C: Integrating the core “flying saw” functions

Integrating the core “flying saw” functions

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 77/107

Manual_SIMOTION Flying Saw_V1.4.doc

Monitoring functions – closed-loop control

•

Please set these parameters corresponding to the system layout and

configuration.

7.4.2 Axis, material web

Configuration

•

Insert a new axis with the name MaterialAxis

• Parameterize the axis as positioning axis

• Set the axis type as linear

• Parameterize as modulo axis with a modulo length greater than the

maximum product length

• All of the additional parameters should be set corresponding to the drive

and encoder data.

Mechanical system

•

For the parameter “distance for each spindle revolution”, the distance

that the material web moves through for one revolution of the drive roll

should be entered.

• Appropriately supplement the other parameters as well as geometry

and design.

Pre-assignment - limits

•

Please enter these parameters corresponding to the system / drive

relationships.

Referencing (homing)

•

Parameterize “not required”

Monitoring functions – closed-loop control

•

Please set these parameters corresponding to the system layout and

configuration.