Saw User Manual

List of contents

SIMOTION Flying Saw A4027118-A0414

V 1.4 Release 06/06/08 7/107

Manual_SIMOTION Flying Saw_V1.4.doc

List of contents

Section A: Prerequisites and objectives .................................................................. 10

1 Basic information ......................................................................................... 11

1.1 Prerequisites................................................................................................... 11

1.1.1 Target group ................................................................................................... 11

1.1.2 Knowledge base ............................................................................................. 11

1.1.3 Technical environment.................................................................................... 11

1.2 Objective and purpose of this standard application........................................ 11

1.2.1 Task description.............................................................................................. 11

1.2.2 Solution using the standard “flying saw” application....................................... 12

1.2.3 Advantages of the standard "flying saw" application ...................................... 13

1.3 Components included in the standard application.......................................... 13

2 Uses ............................................................................................................... 15

2.1 Applications .................................................................................................... 15

2.1.1 Controls that are permitted ............................................................................. 15

2.1.2 Tasks that can be implemented using the core functions............................... 15

2.1.3 Properties and features of the core “flying saw” functions.............................. 16

2.2 Application environment ................................................................................. 17

3 Structure and function ................................................................................. 18

3.1 Design of the "flying saw" ............................................................................... 18

3.1.1 General design ............................................................................................... 18

3.1.2 Physical quantities that can be parameterized ............................................... 18

3.2 Operating states of the "FlyingSaw-FB".......................................................... 20

Section B: The application example as demonstration system............................ 22

4 Installing the hardware and software ......................................................... 23

4.1 Regarding your safety..................................................................................... 23

4.1.1 Safety information and instructions................................................................. 23

4.1.2 Responsibilities of the operator ...................................................................... 24

4.2 Hardware structure and mounting/installation ................................................ 25

4.3 Installing the standard SIEMENS software..................................................... 28

4.4 Downloading the user program and parameterizing the drive in the SIMOTION

D demonstration case ................................................................................ 28

4.4.1 De-archiving the SIMOTION project ............................................................... 28

4.4.2 Resetting SIMOTION D435 to the factory settings ......................................... 28

4.4.3 Re-configuring the double-axis motor module from 3A/3A to 5A/5A .............. 30

4.4.4 Setting the Ethernet interface of the PG/PC................................................... 32

4.4.5 Downloading the hardware configuration after a factory setting..................... 37

4.4.6 Downloading the SIMOTION project of the standard application ................... 38

5 Operator control of the application example ............................................. 41