Saw User Manual

Section B: The application example as demonstration
system
Ot
tl
f
th
li ti
l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 60/107
Copyright © Siemens AG 2008 All rights reserved
Manual_SIMOTION Flying Saw_V1.4.doc
5.2.7 Operator control functions in the status display
The status display of the application can be selected from every operator
screen using the
STATUS button.
Fig. 5-11: Status
You can see the actual state of the FlyingSaw FB in the status display.
The error numbers that are displayed under ErrorID can be viewed under
Chapter 12.2 Possible error messages at the error output ErrorID of the
„FB_BGD_TEMPLATE_FlyingSaw()“.
Errors can be acknowledged using the
QUITT button.
If the FlyingSaw-FB is in the
“error” state, then the Quitt button should be
pressed until the FlyingSaw-FB is in the
“disable” state.