Saw User Manual

Section B: The application example as demonstration
system
Ot
tl
f
th
li ti
l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 55/107
Copyright © Siemens AG 2008 All rights reserved
Manual_SIMOTION Flying Saw_V1.4.doc
Standard operator control
Table 5-3: Standard operator control in the automatic mode
No. Action Comment
1 Initial situation:
The “flying saw” is in the AUTOMATIC-STOPPED mode
2
Using the Sync Position slider switch, enter the position
at which the flying saw reaches the position where the
material web is to be cut.
3
The flying saw starts to move to the starting position by
pressing the Flying Saw STARTPOS button
4
After the starting position has been reached, the flying
saw is in the AUTOMATIC-READY mode
5
The flying saw is enabled for operation using the Flying
Saw START button.
6
The flying saw is in the AUTOMATIC-STANDBY mode
and waits for material.
7
Select the required material web velocity using the
Material Velocity slider.