Saw User Manual

Section B: The application example as demonstration
system
Ot
t
l
f
th
li ti
l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 54/107
Copyright © Siemens AG 2008 All rights reserved
Manual_SIMOTION Flying Saw_V1.4.doc
5.2.5 Operator functions of the process in the automatic mode
Note
The automatic mode is only available, if
• There is no fault,
• Both axes are enabled, and
• For both of these axes, no manual operator control functions are
active.
Fig. 5-7 AUTOMATIC operator screen form for operator functions in the automatic mode