Saw User Manual

Section B: The application example as demonstration

system

li ti

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 51/107

Manual_SIMOTION Flying Saw_V1.4.doc

5.2.3 Machine parameter settings

The standard application allows the following parameters to be adapted:

Machine geometry

•

Distance to sensor

Distance between the flying saw axis and the sensor of the material and

print mark detection

• StartPosition

Position from which the flying saw starts motion to achieve synchronism

(with the material web)

• StartSyncPosition

Position at which the flying saw is synchronized, start of the

synchronous traversing range

• EndSyncPosition

End of the synchronous traversing range

• EndPosition

Maximum traversing range of the flying saw

Flying Saw Axis Accelerations

•

Cut

Acceleration value for synchronization

• Back

Acceleration value for return motion

• Gap

Acceleration value for creating a "gap".

Creating a "gap"

•

GapVelocity

Additional velocity in order to create a gap between the material and the

cut piece