Saw User Manual

Section B: The application example as demonstration
system
Ot
tl
f
th
li ti
l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 45/107
Copyright © Siemens AG 2008 All rights reserved
Manual_SIMOTION Flying Saw_V1.4.doc
12
After the last cut, the “flying saw” automatically moves to
its starting position and waits for new material.
13
Once the material has been completely removed
from the screen area, then you can
either
allow new material to enter by pressing
the Material START button
and continue with Step 8,
or
end the “flying saw” by pressing
the Flying Saw END button.
14
After the “flying saw” has been ended, you can
return to the welcome screen
by pressing the
HOME button
15
Process screen
The process screen is the main screen in the automatic mode of the
application example to control (operator control) the “flying saw”.
Fig. 5-2 Process screen in the automatic mode of the “flying saw”
Mode of the
"FlyingSaw FB“
Flying Saw
Operating state (OMAG)
application example
Position and velocity of the
material and "Flying Saw“