Saw User Manual

Section B: The application example as demonstration

system

li ti

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 43/107

Manual_SIMOTION Flying Saw_V1.4.doc

5.1.2 Brief instructions

Execute the following steps in the sequence as listed in the following table

to demonstrate the application example:

Table 5-1: Brief instructions to demonstrate/present the “flying saw” application example

No. Action Comment

Call the following file

"C:\Siemens\Step7\S7Proj\SAP_FlyingSaw\TDOP\

PRO__00.fwd"

As an alternative, you can also select the operator panel

using Step 7. In the SIMATIC Manager, open the

SAP_FlyingSaw project. You will find the HMI object

OP1 at the project level. Start the runtime from the

context menu (righthand mouse key).

If the connection to the CPU was able to be established,

the screen form appears at the top left - mode: Idle

Check that your PG/PC is set

to PROFIBUS with 12 Mbit/s.

At the bottom left, please click on AUTO

button from the left!)

First activate the print mark simulation by pressing the

Print Mark Simulation ON / OFF

button.

Next, activate the travel to the starting position using the

button Flying Saw STARTPOS