Saw User Manual

Section B: The application example as demonstration
system
I t lli
th
hd
d
ft
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 34/107
Copyright © Siemens AG 2008 All rights reserved
Manual_SIMOTION Flying Saw_V1.4.doc
9
The interface of the control is now
assigned the interface of the PG/PC.
Select this and if it has still not been set,
then set the checkmark for S7ONLINE
access Active.
Acknowledge your entry with OK.
Under certain
circumstances, the
Ethernet line of the
PG/PC will have a
”yellow border”.
10
Please select “Compile and check
everything”
(button ) and acknowledge with OK
11
If any references are made to alarms,
then please close.
12
Before you load the project, please close
NETPRO and set the Ethernet address of
your PG/PC.
Refer to the next Section
Setting the Ethernet address of the PG/PC